poultry farm sheds for rent in lahore

The single egg cage consists of six mesh sheets of front net, side net (2 sheets), top net, rear net and bottom net, and includes egg guard plate, 2 cage doors, and support frame. The cages for poultry farm sheds for rent in lahore are connected by cages with snap rings, and each of the two snap rings is separated by about 50-100 mm. The horizontal wire of the front net is hooked above the cage door, and the horizontal wire of the feeding tip is hooked below, and can slide left and right. The eggshells are installed in the bottom mesh of the side nets to prevent the chickens from eating the eggshells that roll down. The height of the front and bottom cages is 781 mm. The top net is installed obliquely, and the rear net has no passage, and the rest is the same as the top chicken cage. The figure shows the top single chicken cage structure, the lower chicken cage is upwards about 100mm in front, and the rear net is not open.

The structure of the side net for poultry farm sheds for rent in lahore: the side net of the top cage. The side net of the lower cage; due to the inclination of the lower cage top net, the top of the lower layer cage is provided with oblique threads. Since the cage is raised as an adult chicken and the grid spacing is large, it is also unnecessary to open a special grid channel for the drinking water pipe: the hook at the front end of the side net is used to hook the feeding tip to play the role of reinforcement; There is a mesh with a guard egg plate installed; the second horizontal wire at the bottom end is used to fix the entire single cage to the hook of the bracket beam than other horizontal wire ancestors. In the middle of the cage, the general egg cage also has a side net. In this study, a large cage of Zhongtong is used as a feeding unit, so it is necessary to carry out a special feasibility analysis for removing the middle side net of the cage.