poultry cage manufacturers in kerala

The material of the chicken cage can be selected from fiber cement board and glass fiber reinforced plastic, and laid on the top of the cage of the middle and lower chicken cages. The two sides of the outside of the slab are used to support the front end of the bottom layer of the top and bottom chicken cages. The four end points are fixed on the inclined beams and the diagonal braces of the adjacent brackets by the slab jointing plates, and the head and tail end of the slab is fixed at the beginning and the end. The top net that does not touch the cage on the shelf. If a stainless steel plate with a thickness of less than 1 mm is used as the carrier plate. Adjacent manure panels are stacked one above the other, keeping in mind that the pressed dung panels must be on the same side of the direction in which the cage top manure is operating for poultry cage manufacturers in kerala .

The ends of the feeding trough are different in size, the large end is 2.5mm wider than the bottom surface of the small end, and the 1.5mm concave tip is processed downward. When installing, two adjacent feedings are placed, and the small end sleeve of one feeding tip is embedded in the other. The large end of the feeding trough is then fixed together on the same feeding support for poultry cage manufacturers in kerala .

The track is composed of galvanized steel pipes connected end to end, and is connected by a round pipe with a small radius and fixed by plug welding.

There is a drinking water line at the rear of each single cage for poultry cage manufacturers in kerala , a pressure reducer is installed at the first end, and a filter and a dosing device are provided, a deflation valve is arranged at the tail end, and a transparent tube is installed at the pressure reducing device and the deflation valve. Observe the water pressure value at the beginning and the end: set one drinking water nipple for each drinking water pipe between 400-500mm, and use plastic joints between drinking water pipes.